Potable Water Treatment

Suggestions

Products

Requirements - Potable Water Treatment

Overview
Downloads

Water is in short supply so experts are needed when producing it for human consumption. ProMinent has products to cover almost every process used to treat and disinfect potable water and matches these to the prevailing requirements. Of course, we also ensure compliance with local statutory requirements. Oxidation, membrane filtration In water treatment, membrane filtration is the process for removing particles and salts in the water ... more in the glossary and desalination make the water palatable. Our wide range of disinfection solutions (chlorine dioxide Chlorine dioxide is an exceptionally reactive gas, which is not stored due to its instability ... more in the glossary, chlorine, gravity filtration, nanofiltration Nanofiltration is based on the same principle as reverse osmosis Reverse osmosis is a sub-sector within membrane filtration. It is the process with the highest ... more in the glossary. The difference: The separation ... more in the glossary, desalination, silver-ion sterilisation, ultraviolet disinfection and ozonisation) also guarantee absolute disinfection safety.

Downloads for Potable Water Treatment

Selected filters:

Matching downloads

Sort by Document type

A bis Z

Load more matches ...

No more matches available!

Unfortunately, we did not find an appropriate match.

All words written correctly?
Search again with fewer or different search terms?

Please try again later

Service Unavailable

The server is temporarily unable to service your request due to maintenance downtime or capacity problems. Please try again later.

Overview

Downloads

Suitable products - Potable Water Treatment

Solenoid-Driven Metering Pump beta

Capacity range 0.74 – 32 l/h, 25 – 2 bar

All-purpose solenoid-driven metering pump for metering liquid media in water treatment and chemical processes: Solenoid-driven metering pump beta. Cost-effective, overload-proof and adaptable to existing signal transducers.

Solenoid-Driven Metering Pump gamma/ X

Feed rate of product range 1 ml/h – 45 l/h; 25 – 2 bar

The solenoid-driven diaphragm metering pump gamma incorporates a wealth of eX cellent ingenuity! With integrated pressure measurement, it ensures the smooth running of your metering process. The gamma/ X is ideal for all metering work involving liquid media.

Solenoid-Driven Metering Pump gamma/ XL

Feed rate of product range 4 ml/h – 80 l/h; 25 – 2 bar

The gamma/ XL is a smart, connectible solenoid-driven metering pump that is setting new standards in terms of productivity, reliability and cost-effectiveness.

Motor-Driven Metering Pump Sigma/ 1 (Basic type)

Capacity range 17 – 144 l/h, 12 – 4 bar

The Sigma/ 1 Basic is an extremely robust motor-driven metering pump with patented multi-layer safety diaphragm for excellent process reliability. It offers a wide range of power end designs, such as three-phase or 1-phase AC motors, also for use in areas at risk from explosion.

Motor-Driven Metering Pump Sigma/ 2 (Basic Type)

Capacity range 50 – 420 l/h, 16 – 4 bar

Robust motor-driven metering pumps like the Sigma/ 2 Basic guarantee excellent process reliability with their patented multi-layer safety diaphragm. The diaphragm metering pump offers a number of power end versions, also suitable for use in areas at risk from explosion.

Motor-Driven Metering Pump Sigma/ 3 (Basic Type)

Capacity range 146 – 1,030 l/h, 12 – 4 bar

The patented multi-layer safety diaphragm for excellent process reliability is just one feature of the extremely robust motor-driven metering pump Sigma/3 Basic. It also offers a wide range of power end versions, such as three-phase or 1-phase AC motors, also for use in ATEX areas.

Motor-Driven Metering Pump Sigma X Control Type – Sigma/ 1 - S1Cb

Capacity range S1Cb: 21 – 117 l/h, 12 – 4 bar

The Sigma control type is a smart motor-driven metering pump that is setting new standards in terms of productivity, reliability and safety.

Motor-Driven Metering Pump Sigma X Control Type – Sigma/ 2 - S2Cb

Capacity range S2Cb: 61 – 353 l/h, 16 – 4 bar

The Sigma control type is a smart motor-driven metering pump that is setting new standards in terms of productivity, reliability and safety.

Motor-Driven Metering Pump Sigma X Control Type – Sigma/ 3 - S3Cb

Capacity range S3Cb: 182 – 1,040 l/h, 12 – 4 bar

The Sigma control type is a smart motor-driven metering pump that is setting new standards in terms of productivity, reliability and safety.

Turbidity measuring point DULCOTEST DULCO turb C

Measuring range 0 – 1,000 NTU

Turbidity measurements with DULCOTEST DULCO turb C: Compact measuring instrument that uses light scatter to measure turbidity, with a large measuring range and different designs to comply with ISO and EPA standards. Available with or without automatic cleaning.

Controller DULCOMETER D1Cb/D1Cc

The controller DULCOMETER D1Cb/D1Cc can be used for control tasks in potable water treatment, wastewater treatment and many other areas. Safe, convenient and clear, thanks to the large illuminated graphic display, plain text operating menu and pH sensor monitoring.

Controller DULCOMETER Compact

As a controller in water analysis, the DULCOMETER Compact is the correct controller for control tasks that require only a 1-way control.

Ultrafiltration System DULCOCLEAN UF

8 – 75 m³/h filtrate output

Ultrafiltration system DULCOCLEAN UF reliably and safely uses membrane technology to remove turbidity, particles and microbiological contamination.

Reverse Osmosis System DULCOSMOSE BW

Permeate output 2,000 – 50,000 l/h

Reverse osmosis system DULCOSMOSE BW is the standard model for the modern desalination of brackish water. Equipped with the latest generation of 'high rejection low-pressure' membranes, this system achieves maximum permeate output with moderate operating pressures, thereby lowering investment and operating costs.

Reverse Osmosis System DULCOSMOSE SW

Permeate output 780 – 29,000 l/h

The reverse osmosis system DULCOSMOSE SW is the standard model for modern desalination of salt water. Equipped with the latest generation of 'high rejection low-pressure' membranes, this system achieves maximum permeate output with moderate operating pressures, thereby lowering investment and operating costs.

Photometer

Photometers measure nearly all disinfectants and the pH value based on the photometric principle. They are portable, compact and make safe, simple measurement possible.

DULCOTEST sensors for conductivity

Graduated measuring ranges 0.01 µS/cm – 2,000 mS/cm

Conductivity sensors for optimum process integration: DULCOTEST sensors meet a wide range of measuring requirements and allow the best solution to any given measuring task to be achieved.

DULCOTEST sensors for dissolved oxygen

Measuring range: 0.1 – 20 mg/l

Widely used sensor for the measurement of oxygen dissolved in water above 0.1 ppm to oxygen saturation. For installation in standard immersion pipes or in the bypass line of the process flow. Use in aeration tanks of clarification plants, waterworks, in fish breeding or to monitor surface water. Minimal maintenance due to visual measuring principle.

DULCOTEST sensors for fluoride

Graduated measuring ranges 0.05 – 100 mg/l

Accurate measurement of fluoride with DULCOTEST sensors in the monitoring of potable water and wastewater, suitable for pH values up to 9.5.

DULCOTEST sensors for free chlorine

Graduated measuring ranges 0.01 – 200 mg/l, special measuring range up to 1,000 mg/l

The application-based DULCOTEST sensors for free chlorine deliver precise measured values and a high degree of monitoring and process reliability in any disinfection application.

DULCOTEST pH sensors

Graduated pH measuring ranges 0 – 14

pH measurements with DULCOTEST sensors: Precise, reliable and application-adapted measured values in real-time. Control, regulate and monitor chemical processes with the aid of precise measured values.

DULCOTEST sensors for total chlorine

Graduated measuring ranges 0.01 – 10 mg/l

Reliably measure total chlorine with the versatile DULCOTEST sensors for total chlorine. Accurate measured values and a high degree of monitoring and process reliability are guaranteed.

UV System DULCODES LP

Flow up to 523 m³/h

The unique UV systems DULCODES LP are synonymous with pioneering water treatment – efficient and free of chemicals.

UV System DULCODES LP certified

Flow up to 406 m³/h

UV system DULCODES LP for drinking water disinfection, comprehensively certified to internationally-recognised DVGW/ÖVGW/SVGW/UVDGM standards. Looking to the future, the systems have already been type-tested in accordance with the latest DIN 19294-1:2020-08 test regulation. Successful certification officially confirms the precise 50-100% control range of the highly efficient VARIO-Flux lamps with dynamic lamp heating.

NEW

Electrolysis System CHLORINSITU IIa 60 – 2,500 g/h

Output 60 – 2,500 g/h of chlorine

CHLORINSITU IIa is a compact on-site electrolysis system for the production of a low-chlorate hypochlorite solution from salt and electricity. Key advantages are its simple process management and excellent system safety through integrated ventilation and bleeding.

Nanofiltration System DULCOSMOSE NF

Permeate outputs from 1 to 50 m³/h, higher outputs possible on request

As a nanofiltration system, the DULCOSMOSE NF, a compact and value-for-money unit, can handle partial desalination in industrial applications. Maximum permeate output at low operating pressures ensures low operating costs thanks to the "ultra low pressure" diaphragm.

Measuring and Control System DULCOTROL Potable Water/F&B

Monitoring and treatment of potable and similar types of water with DULCOTROL Potable water/F&B – the compact measuring and control system specially designed for water treatment in waterworks and in the food and beverage industry.

Controller DULCOMETER diaLog DACb

Do you wish for a simple controller for water analysis? One that is easy to operate and with which you can freely select between all common measured variables per channel? There is one: our all-rounder DULCOMETER diaLog DACb! What is more, it is Ethernet-/LAN-capable and can be ideally integrated into existing networks.

Controller DULCOMETER diaLog X

The DULCOMETER diaLog X multi-parameter controller ensures that complex water treatment systems are operated as efficiently as possible. The controller is highly flexible and suitable for many sensor parameters.

DULCOMETER transmitter 4 - 20 mA

The 4…20 mA transmitters for pH, ORP, fluoride, temperature and PEROX sensors enable safe and fault-free transmission of the sensor signal to the controller. Thanks to simple installation directly on the sensor, a stable signal transmission over larger distances can be ensured too.

DULCOTEST sensors for hydrogen peroxide

Graduated measuring ranges 0.2 – 2,000 mg/l, special measuring ranges up to 100,000 mg/l

Hydrogen peroxide measurement with DULCOTEST sensors: Efficient and reliable determination of the concentration of hydrogen peroxide - can be used in a wide range of applications.

Peristaltic pump DULCOFLEX DFXa

Feed rate of 10 ml/h to 65 l/h at up to 7 bar back pressure

DULCOFLEX DFXa meters outgassing, viscous, abrasive or shear-sensitive media and is setting new standards in metering. Linear and reproducible metering (± 1 %) is guaranteed with this peristaltic pump under all process conditions. Hose replacement is a very simple process.

NEW

Sensor bypass armature Modular BAMa

Up to 9 functional modules can be freely configured in a single fitting.

The modular bypass armature BAMa accommodates ProMinent sensors for water treatment. The armature is simply installed in a bypass of the main process line. It is available in various variants, each perfectly designed for special water treatment applications – from drinking water, water for pool & wellness to industrial water.